Lucent Technologies lucent Signaling Link Board Check (#643)

DEFINITY Enterprise Communications Server Release 6

Maintenance for R6vs/si

555-230-127 Issue 1

August 1997

Maintenance Object Repair Procedures

Signaling Link Board Check (#643)

1003 ABORT The system could not allocate a tone receiver for the test. The system may

be oversized for the number of Tone Detectors present or some Tone

Detectors may be out-of-service.

1. Look for TTR-LEV errors in the Error Log. If present, refer to TTR-LEV

(TTR Level) Maintenance documentation.

2. Look for TONE-PT errors in the Error Log. If present, refer to TONE-PT

(Tone Generator) Maintenance documentation.

3. If neither condition exists, retry the test at 1-mi nute int erval s a maxim um

of 5 times.

2000 ABORT Response to the test request was not received within the allowable time

period.

1. Retry the command at 1-minute intervals a maximum of 5 times.

2020 ABORT The test did not run due to an already existing error on the specific port or a

more general circuit pack error.

1. Examine Error Log for existing errors again st thi s port or t he c ircuit pack

and attempt to diagnose the already existing error.

2100 ABORT Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals a maximum of 5 times.

Any FAIL The NPE of the tested port was found to be transmitting in erro r. Thi s causes

noisy and unreliable connections.

1. Replace the DS1-BD Interface circuit pack.

PASS The port is able to communicate over the TDM Bus.

Table 10-236. TEST #6 NPE Crosstalk Test — Continued

Error

Code Test

Result Description/ Recommendation

Continued on next page