DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127 Issue 1
August 1997
Maintenance Object Repair Procedures

Page10-166BRI-PORT (ISDN-BRI Port), ABRI-PORT (ASAI ISDN-BRI Port)

10
Figure 10-8. Path of the BRI Port Local TDM Loop Around
Table 10-58. TEST #619 BRI Port Local TDM Loop Around
Error
Code Test
Result Description/ Recommendation
1000 ABORT The system resources required to run this test are not available. The port
may be busy with a valid call. Use the display port PCSSpp command to
determine the station extension or trunk gr oup/m ember num ber of the port.
Use the status bri-port PCSSpp command to determine the service state
of the port. If the service state indicates that the port is i n use, th en th e port
is unavailable for certain tests. (Refer to the "Status Commands" section in
Chapter 8, "Maintenance Commands and Trouble-Clearing Aids", for a full
description of all possible states.) Wait until the port is idle before
retesting.
1. If the port is idle, then retry the command at one-minute intervals a
maximum of five times.
2. If the test continues to abort, escalate the problem.
Continued on next page
Tone
Generator Tone
Detector
BRI Line
Board
TDM Bus