Mitsubishi Electronics FR-V500 Checks prior to test run, Setting the speed and running the motor

Checks prior to test run

3 RUN AND OPERATION

3.1 Checks prior to test run

Installation check

Check that the inverter is installed correctly in a correct place. (Refer to page 6.)

Wiring check

Check that wiring is correct. (Refer to page 7.)

3.2 Basic operation (Speed setting, run, speed meter adjustment)

3.2.1Setting the speed and running the motor

(1)Choosing PU operation mode (operation from the operation panel (FR-DU04-1)) and run- ning at 150r/min

Operation

1. Power on Operation mode check

The external operation mode (EXT) is selected when switching power on with factory setting.

ON

Display

FR-DU04-1CONTROL PANEL

Hz/r

A

V

Make sure that the operation command indication "PU" is lit. If it does not appear, press MODE to choose the operation

mode, and press to choose the PU operation mode. When the desired result is not obtained, set the PU operation mode in Pr.79.

MON EXT PU

REV FWD

2. Running speed setting			FR-DU04-1	CONTROL PANEL
			(or)		Hz/r
Set the running speed to 150r/min.					A
					V
First, press MODE		to choose the speed setting mode.	MON	EXT	PU
				REV	FWD
Then, press		to change the setting, and press
SET to write the value.)			FR-DU04-1
3. Start				CONTROL PANEL
		FWD	(or) REV		Hz/r
Press					A
	FWD or REV .				V
The motor starts. The mode is automatically switched			MON	EXT	PU
				REV	FWD
to the monitoring mode and the output speed is displayed.
4. Stop			FR-DU04-1	CONTROL PANEL
					Hz/r
Press	STOP	.
					A
	RESET
The motor is decelerated to a stop.					V
			MON	EXT	PU
				REV	FWD

REMARKS

•The operation speed can be changed by changing the preset speed during operation following the steps 2 and 3 above.

•For monitor display changes by MODE , refer to page 27.

•To select the PU operation mode in Pr.79 "operation mode selection", set "1" in the parameter. Refer to page 52 for details.

3

RUN AND OPERATION

22