Mitsubishi Electronics FR-V500 Names and functions of the opera- tion panel Copy mode

Names and functions of the opera- tion panel

3.3.7Copy mode

By using the operation panel (FR-DU04-1), the parameter values can be copied to another inverter (only the FR- V500 series).

1)Operation procedure

After reading the parameter values from the copy source inverter, connect the operation panel to the copy des- tination inverter, and write the parameter values.

After writing the parameter values to the copy destination inverter, always reset the inverter, e.g. switch power off once, before starting operation.

Parameter setting mode

FR-DU04-1	CONTROL PANEL		FR-DU04-1	CONTROL PANEL
		Hz/r			Hz/r
		A			A
		V			V
MON EXT		PU	MON EXT		PU
	REV	FWD		REV	FWD

FR-DU04-1

CONTROL PANEL

FR-DU04-1

CONTROL PANEL

FR-DU04-1

CONTROL PANEL

FR-DU04-1

CONTROL PANEL

Hz/r

SET

Hz/r

Hz/r

Hz/r

A

A

A

A

V

V

V

V

MON

EXT

PU

MON

EXT

PU

MON

EXT

PU

MON

EXT

PU

REV

FWD

REV

FWD

REV

FWD

REV

FWD

Press for SET 1.5s

(Caution 1)	Press for	SET
	1.5s

(Caution 1)	Press for	SET
	1.5s

(Caution 1)

FR-DU04-1	CONTROL PANEL		FR-DU04-1	CONTROL PANEL		FR-DU04-1	CONTROL PANEL
		Hz/r			Hz/r			Hz/r
		A			A			A
		V			V			V
MON EXT		PU	MON EXT		PU	MON EXT		PU
	REV	FWD		REV	FWD		REV	FWD
Parameter read			Parameter write			Parameter verify

After writing the parameter values, always reset the inverter prior to

Connect to copy destination inverter. the start of operation.

CAUTION

1.While the copy function is being activated, the monitor display flickers. The display returns to the lit- up state on completion of the copy function.

2.If a read error occurs during parameter read, "read error (E.rE1)" is displayed.

3.If a write error occurs during parameter write, "write error (E.rE2)" is displayed.

4.If a data discrepancy occurs during parameter verify, the corresponding parameter number and "ver- ify error (E.rE3)" are displayed alternately. If the directly preset speed or jog speed setting differs,

"verify error (E.rE3)" flickers. Press SET to ignore this display and continue verify.

5.When the copy destination inverter is not the FR-V500, "model error (E.rE4)" is displayed.

Reference: It is recommended to perform parameter read after completion of parameter setting. (When performing auto tuning, it is recommended to perform read after completion of auto tuning.) When the inverter has been changed, performing parameter write from the operation panel fitted to a new inverter completes parameter setup.

31