Mitsubishi Electronics FR-V500 Position command, Right selection, Position feed forward, Gain

Function list (Extended function parameters)

							At-a-glance Guide to Func-
								tions
							": Usable function
Function	Parameter					Cus-	×: Unusable function
							* : Functions that can be used
		Name		Outline	Factory	tomer
							for param eter-set position con-
					Setting	Set-
								trol
						ting
							Vector Control
							Speed	Torque	Position
							control	control	control
		Position command	Select the position command right for position control.
	419		0, 1		0		×	×	"
		right selection	0: Conditional position feed function by contact input
			1: Position command by pulse train input (when the FR-V5AP is fitted).
		Command pulse					×	×
	420	scaling factor			1				"
		numerator	Set the electronic gear. Pr. 420 is a numerator and Pr. 421 is a denominator.
		Command pulse	0 to 32767				×	×
	421	scaling factor			1				"
		denominator
	422	Position loop gain	Set the gain of the position loop.		25s-1		×	×	"
control				-1
		Position feed forward	Function to cancel a delay caused by the droop pulses of the deviation counter.
			0 to 150s
Torque	423	gain	0 to 100%		0%		×	×	"
		Position command	Used when rotation has become unsmooth at a large electronic gear ratio (about 10
	424	acceleration/	times or more) and low speed.		0s		×	×	"
		deceleration time	0 to 50s
		constant
	425	Position feed forward	Enters the primary delay filter in response to the feed forward command.		0s		×	×	"
		command filter	0 to 5s
	426	In-position width	The in-position signal turns on when the droop pulses become less than the setting.		100		×	×	"
			0 to 32767 pulses		pulses
	427	Excessive level error	An error becomes excessive when the droop pulses exceed the setting.		40K		×	×	"
			0 to 400K pulses		pulses
	430	Pulse monitor	0 to 5, 9999		9999		×	×	"
		selection
	450	Second applied	0, 10, 30, 9999		9999		"	"	"
		motor
motor	451	Second motor control	Select the method of controlling the second motor.		9999		"	"	"
		method selection	20, 9999
Second	452	Second electronic	Set the electronic thermal relay value of the second motor.		9999		"	"	"
		thermal O/L relay	0 to 500A, 9999
	453	Second motor	Set the capacity of the second motor.		Inverter		"	"	"
		capacity	0.4 to 55kW		capacity
	454	Number of second	Set the number of poles of the second motor.		4		"	"	"
		motor poles	2, 4, 6

PARAMETERS

Parameter

5

64