Mitsubishi Electronics FR-V500 instruction manual Operation mode

Names and functions of the opera- tion panel

3.3.4Parameter setting method (Example: Method to enable extended function parameters)

•A parameter value may either be set by updating its parameter number or setting the value digit-by-digit using

.

•To write the setting, change it and press SET for 1.5 seconds.

Example: To change the Pr. 160 "extended function selection" setting from "0" (extended function parameter

invalid) to "1" (extended function parameter valid) (Refer to page 53 for details of Pr. 160.)

Press MODE to choose the "parameter setting mode".

Parameter setting mode

FR-DU04-1		CONTROL PANEL				Most significant
						digit flickers
				Hz/r
					SET
				A
				V
MON EXT				PU
	REV			FWD			⋅ 1 time
							or
		MODE					⋅ 9 times
To 3.3.5 Operation mode
								SET
							0 to 9
			Current setting				Setting change
SET
								Press for
								1.5 s
								SET
							Setting write

Flicker

Middle digit	Least significant
flickers	digit flickers

⋅ 6 times or

⋅ 4 times

SET

0 to 9

If appears

1) When [FWD] or [REV] indication is lit,

stop operation by pressing STOP or MON EXT PU

RESET

REV FWD

turning off the forward rotation (STF) or reverse rotation (STR) signal connected to the control terminal.

2)You cannot set any value outside the parameter setting range. Write a value within the setting range.

"1" (extended function parameter valid) has been set in Pr. 160.

If the value and parameter number do not flicker and appears instead, you did not press SET for 1.5 seconds when

writing the value.

Press once, press SET , and restart the setting from the beginning.

3

3.3.5Operation mode

External operation			PU operation			PU jog operation
FR-DU04-1	CONTROL PANEL		FR-DU04-1	CONTROL PANEL		FR-DU04-1	CONTROL PANEL
		Hz/r			Hz/r			Hz/r
		A			A			A
		V			V			V
MON	EXT	PU	MON	EXT	PU	MON	EXT	PU
	REV	FWD		REV	FWD		REV	FWD
				MODE					MODE
MODE

o 3.3.6 Help mode

REMARKS

If one operation mode cannot be switched to another, check the following items.

•External input signals ..... Make sure that the STF and STR signals are off.

•Parameter setting ........... Check the Pr. 79 setting.

When the Pr. 79 "operation mode selection" setting is "0" (factory setting), the inverter is placed

in the external operation mode at input power-on. At this time, press MODE on the operation panel

twice and press (press PU when the parameter unit (FR-PU04V) is used) to switch to the PU operation mode. For the other values (1 to 8), the operation mode is limited accordingly.

RUN AND OPERATION

28