(2) When installing with USB memory

Now installing BootOS.

Reboot.

1. Power off the GOT, and install the USB memory where the BootOS, standard monitor OS or project data is stored in the USB interface of the GOT. The BootOS cannot be stored in the USB memory where the standard monitor OS or project data is stored.

2. Power on the GOT while pressing upper left corner of the GOT screen. (1-point press installation function)

3. The BootOS or standard monitor OS is installed in the built-in flash memory.

Do not pull out the USB memory or power off the GOT while install execution.

4. The GOT restarts automatically after the installation is completed.

(When the standard monitor OS is already installed, the GOT restarts by touching the [OK] button.)

5. After confirming normal restart, remove USB memory from the USB interface of the GOT.

For removing methods of the USB memory, refer to the following.

13.2.9 USB device status display

POINT

(1)Drives to be used

When installing OS at power-on, use the A or E drive.

(2)Installation by pressing upper left corner of the GOT screen

When the OS boot drive is set to the A or E drive, installation by pressing upper left corner of the GOT screen is not available.

16 - 6

16. INSTALLATION OF COREOS, BOOTOS AND STANDARD MONITOR OS

 

16.3 BootOS and Standard Monitor OS Installation Using SD card or USB Memory