Mitsubishi Electronics GOT1000 7.2 Wiring inside and outside the panel, 7.2.1Wiring inside, 7.2.2Outside the panel

7.2 Wiring inside and outside the panel

7.2.1Wiring inside

Run power lines, servo amplifier drive wires, and communication cables so that they do not cross each other. Noise interference that is generated by cables that cross each other may cause malfunctions.

Surge suppressors are an effective way to filter out surge noise that is generated from no fuse breakers (NFB), electromagnetic contactors (MC), relays (RA), solenoid valves, and induction motors.

For surge killers, refer to the section to follow.

7.2.3 Attaching surge killers to control equipment

Uncrossed power lines and

Crossing power lines and communication cables

communication cables

Power

cable

NFB

PLC

GOT connection cable

cable

NFB

PLC

GOT connection cable

PLC I/O wire

Drive control wire

Terminal block

7.2.2Outside the panel

To pull the power line and communication cable out of the panel, make two pullout holes away from each other and pull the cables through.

Putting both cables through the same pullout hole will increase noise interference.

Power line
	Power line	Connection
		cable
Connection
cable
Pullout hole	Pullout hole

Keep the power line and communication cable inside the duct at least 100mm away from each other. If that is not possible, the use of a metal separator inside the duct can reduce noise interference.