1. Write the CoreOS from GT Designer3 to the SD card.
For details of GT Designer3 operation, refer to the following manual.
GT Designer3 Version1 Screen Design Manual (Fundamentals)
2. After confirming that the GOT is powered off, install the SD card in the GOT. After installing, switch the SD card access switch on.
3. Powering the GOT on displays the screen on the left.
To cancel the installation, power the GOT off and remove the SD card.
4. Turning the SD card access switch off executes CoreOS installation.
5. When the installation is completed, the dialog as shown on the left is displayed.
(The POWER LED of the GOT blinks (green/ orange) at the installation completion.)
6. Confirm that the message is displayed and power the GOT off.
7.
8. Powering the GOT on again displays the screen as shown on the left.
(The GOT goes to the status of factory shipment.) Install OS (Standard monitor OS, communication driver, etc.) or download project data as required.
16 - 12 | 16. INSTALLATION OF COREOS, BOOTOS AND STANDARD MONITOR OS |
| 16.5 CoreOS |