NETGEAR FVS338 manual Inbound Rules Fields, Priorities on

	FVS338 ProSafe VPN Firewall 50 Reference Manual
Table 4-2. Inbound Rules Fields
Item	Description
Services	Select the desired Service or application to be covered by this rule. If the desired
	service or application does not appear in the list, you must define it using the
	Services menu (see “Adding Customized Services” on page 4-18).
Action	Select the desired action for packets covered by this rule:
	• BLOCK always
	• BLOCK by schedule, otherwise Allow
	• ALLOW always
	• ALLOW by schedule, otherwise Block
	Note: Any inbound traffic which is not allowed by rules you create will be blocked by
	the Default rule.
Select Schedule	Select the desired time schedule (i.e., Schedule1, Schedule2, or Schedule3) that will
	be used by this rule.
	• This drop down menu gets activated only when “BLOCK by schedule, otherwise
	Allow” or “ALLOW by schedule, otherwise Block” is selected as Action.
	• Use schedule page to configure the time schedules.
LAN Server	This LAN address determines which computer on your network is hosting this service
	rule. (You can also translate this address to a port number.).
Translate to Port	Check the “Translate to Port Number” and enter a port number if you want to assign
Number	the LAN Server to a specific port.
WAN Users	These settings determine which Internet locations are covered by the rule, based on
	their IP address. Select the desired option:
	• Any – All Internet IP address are covered by this rule.
	• Single address – Enter the required address in the start fields.
	• Address range – If this option is selected, you must enter the start and finish fields.
WAN Destination IP	These settings determine the destination IP address applicable to incoming traffic.
Address	This is the public IP address that will map to the internal server; it can either be the
	address of the WAN1 or WAN2 ports or another public IP address.
QoS Priority	This setting determines the priority of a service, which in turn, determines the quality
	of that service for the traffic passing through the firewall. By default, the priority
	shown is that of the selected service. The user can change it accordingly. If the user
	does not make a selection (i.e, leaves it as None), then the native priority of the
	service will be applied to the policy. See “Specifying Quality of Service (QoS)
	Priorities” on page 4-20.
Log	This determines whether packets covered by this rule are logged. Select the desired
	action:
	• Always – always log traffic considered by this rule, whether it matches or not. This
	is useful when debugging your rules.
	• Never – never log traffic considered by this rule, whether it matches or not.
Firewall Protection and Content Filtering		4-5

v1.0, March 2008