|
| FVS338 ProSafe VPN Firewall 50 Reference Manual |
|
| |
Table | ||
|
| |
Message | Dec 1 12:11:27 [FVS338] [wand] [LBFO] Restarting WAN1_ | |
| Dec 1 12:11:31 [FVS338] [wand] [LBFO] Restarting WAN2_ | |
| Dec 1 12:11:35 [FVS338] [wand] [LBFO] WAN1(UP), WAN2(UP)_ | |
| Dec 1 | 12:24:12 [FVS338] [wand] [LBFO] WAN1(UP), WAN2(DOWN)_ |
| Dec 1 | 12:29:43 [FVS338] [wand] [LBFO] Restarting WAN2_ |
| Dec 1 | 12:29:47 [FVS338] [wand] [LBFO] WAN1(UP), WAN2(DOWN)_ |
Explanation | Message 1 and Message 2 indicate that both the WANs are restarted. | |
| Message 3: This is a message shows that both the WANs are up and the traffic | |
| is balanced between the two WAN interfaces. | |
| Message 4: This message shows that one of the WAN links is down. At this | |
| point the entire traffic is directed through the WAN which is up | |
Recommended Action | None |
|
|
|
|
Auto Rollover
When WAN mode is configured to Auto Rollover, primary link is active and secondary acts as a backup. When primary link goes down, secondary becomes active until primary comes up. The device monitors the status of the primary link by the configured WAN Failure Detection method.
This section describes the logs generated when the WAN mode is set to auto rollover.
System Logs and Error Messages |