Nortel Networks 14.2 manual Restart the router by entering boot, Enter Manager to log

Configuring Remote Access for AN and Passport ARN Routers

If the line appears in the command display, proceed to step 5; otherwise, do the following:

a.Enter bconfig config local.

For information about the bconfig command, see “Setting the Boot Configuration” in Chapter 4.

b.Restart the router by entering boot.

The Technician Interface login prompt appears.

c.Enter Manager to log in.

The Technician Interface command-line prompt appears.

5.Enter dir to check the contents of the flash memory card.

The software image file (an.exe or arn.exe), configuration file (config), and Quick-Start script file (install.bat or inst_arn.bat) should appear among the files listed.

6.Enter one of the following commands to start the Quick-Start script:

• For the AN/ANH: run install.bat

• For the ARN: run inst_arn.bat

7.Follow the script online.

See the list of Quick-Start commands in Table C-1.

C-14 308614-14.20 Rev 00