Configuring Remote Access for AN and Passport ARN Routers
The script begins to test the IP configuration (Figure C-1).
Testing local IP interface
ping
IP ping: 192.32.00.000 is alive (size - 16 bytes)
IP ping: 192.32.00.000 is alive (size - 16 bytes)
IP ping: 192.32.00.000 is alive (size - 16 bytes)
IP ping: 192.32.00.000 is alive (size - 16 bytes)
IP ping: 192.32.00.000 is alive (size - 16 bytes)
This test attempts to ping the Site Manager workstation.
NOTE: If routing has not yet converged, an attempt
to ping the Site Manager workstation may fail. If this happens, you may either enter a new IP address or quit and wait a short period of time and try again from the TI command line.
Type q<return> to cancel this test.
Enter IP address of Site Manager workstation:
Figure C-1. Quick-Start IP Configuration Test
10.To continue with the IP configuration test, enter the IP address for the Site Manager workstation.
To cancel the test, type q.
11.For the ARN only, specify whether you want to configure another interface.
Type n to stop the
To configure another interface, type y to return to step 6.
12.At the Technician Interface prompt, enter logout to exit the Technician Interface.
After the router creates and tests the configuration, it starts using the information you entered to bridge and route traffic. To configure the router interfaces using Site Manager, see Configuring and Managing Routers with Site Manager.
|
