Oki 6120E manual Ps aux grep lpd

Section 4 - Appendix B - Application Considerations

Configuring Sun-OS v4.1.x or Ultrix v4.2 for Printing with the OkiLAN 6120e

This application note describes the configuration of the printing system on the Sun-OS ver 4.1.x and Ultrix ver.

4.2of the UNIX operating system. For clarity and brevity, the following specific names will be used to represent general devices or concepts.

•lj4 - The local queue name on the Sun-OS or Ultrix system to which print jobs that are destined for a printer attached to the OkiLAN 6120e will be directed.

•OKIPRINTER - The host name of the remote system which is the OkiLAN 6120e. For example, to telnet to the OkiLAN 6120e and invoke the OkiLAN 6120e Configuration utility, you would type telnet OKIPRINTER. A host name is not required for the OkiLAN 6120e, the IP Address may be used.

•yourqueuename - This is the name of the queue on the OkiLAN 6120e and must end with 1, 2, 3 or 4, depending on the port selected to service the print jobs.

If FF, LF or NF are the last two letters of the queue name, the job will be converted accordingly. See pages IV-15 and IV-16 for more information on remote queue names.

Prerequisites

Before you proceed, the following prerequisites must be met:

1.The name OKIPRINTER and the IP address assigned to the OkiLAN 6120e are in the “/etc/hosts” file on the Sun-OS or Ultrix system.

2.Make sure the LPD daemon is running on the Sun- OS or Ultrix system by issuing the following command at the UNIX prompt:

ps aux grep lpd

TCP/IP

OKI OkiLAN 6120e User’s Guide IV - 79