Section 5 - Chapter 2 - Installation
•The initial installation requires the file server to be brought down and then back up again. This may be a consideration when you are planning your install.
Depending on your current configuration, the following software may also be needed:
•Printer driver installation diskettes. These diskettes are provided with the OS/2 operating system or are available from the printer manufacturer.
•LAN Manager or LAN Server installation diskettes.
Note: It is strongly recommended that you make backup copies of the OS2.INI and OS2SYS.INI files before you install the OkiLAN 6120e. Follow the directions in your OS/2 documentation to back up these files.
Installing the Utilities Software
Two software utilities are provided with the OkiLAN 6120e: INSTALL and OkiNet for OS/2.
Install
The INSTALL utility copies both software utilities to your OS/2 server and registers the OKI application with the OS2.INI file. You will need to run INSTALL one time only.
OkiNet for OS/2
The OkiNet for OS/2 utility completes the initial installation of the OkiLAN 6120e. In addition, you can run the utility as needed to modify the configuration of the OkiLAN 6120e or to view port information.
Note: The directory where OKI DLL files install, c:\OS2\DLL, must be the first entry in the LIBPATH command located in the CONFIG.SYS file. When you reboot the system, the OS/2 spooler will load the OKI Network Printer Redirector.
V - 6 | OKI OkiLAN 6120e User’s Guide |
