Oki 6120E manual Saving the Configuration

Section 3 - Chapter 2 - OkiNet for NetWare

Trap Destination

•NetWare Protocol - Enter the network number and hardware address, respectively, to which traps will be sent. To broadcast traps to all addresses on all networks, enter FFFFFFFF (8 characters) in the first field and FFFFFFFFFFFF (12 characters) in the second field. To broadcast traps to all addresses on a specific network, enter the network number in the first field and then FFFFFFFFFFFF (12 characters) in the second field.

•TCP/IP Protocol - Enter the IP address to which traps will be sent. The IP address must follow the format XXX.XXX.XXX.XXX, where each XXX is a number from 0 to 255. To broadcast traps to all hosts on the local subnet, enter 255.255.255.255.

Ports to Trap

Select the output ports on which you wish traps to be active.

Printer Traps

Select the printer traps to be activated. The following printer conditions may cause a printer trap to occur if the OKI printer model supports the features:

•On-line

•Off-line

•No Printer Attached

•Paper Out

•Toner Low

•Paper Jam

•Door Open

•Printer Error

Note: Toner Low, Paper Jam and Door Open require the printer to be set in PCL or Auto mode.

Saving the Configuration

Once all settings have been defined, select OK. The settings will be saved and you will be returned to the main OkiNet for NetWare screen.

III - 16 OKI OkiLAN 6120e User’s Guide