COMSPHERE 3900 Series Modems

Table 4-2

(3 of 5)

DTE Dialer Configuration Options

CarriageRtn Char: 013 ASCI

Nxt " 013 ASCI

This configuration option only appears if DTE Dialer Type is configured for AT.

Carriage Return Character. Allows you to change the ASCII character used to terminate an AT command to any ASCII value from 0 to 127.

The AT command is S-Register S3=n, where n is a value from 0 to 127.

Backspace Char: 008 ASCI

Nxt " 008 ASCI

This configuration option only appears if DTE Dialer Type is configured for AT.

Backspace Character. Sets the character used to perform a backspace in Command mode.

The AT command is S-Register S5=n, where n is a value from 0 to 127.

Linefeed Char: 010 ASCI

Nxt " 010 ASCI

This configuration option only appears if DTE Dialer Type is configured for AT.

Line Feed Character. Sets the character used to perform a line feed in Command mode for responses from the modem.

The AT command is S-Register S4=n, where n is a value from 0 to 127.

Result Codes: Enable

Nxt Enable Disable EnableInOrig

This configuration option only appears if DTE Dialer Type is configured for AT.

Result Codes. Result codes are informational messages (such as Connect and Ring) sent from the modem and displayed on the asynchronous DTE terminal. (For a list of Result Codes, refer to Table 5-1 in Chapter 5, AT Commands and S-Registers.)

HEnable

Modem sends result codes to the DTE.

HDisable

Modem does not send result codes to the DTE.

HEnable in Originate

For UNIXr applications, enable result codes only on the originating modem. This prevents the DTE on the answer side from interpreting result codes as login attempts.

The AT command for Enable is Q0.

The AT command for Disable is Q1.

The AT command for Enable in Originate mode is Q2.

4-22

November 1996

3910-A2-GN32-30

Page 125
Image 125
Paradyne 3910 operation manual CarriageRtn Char 013 Asci Nxt 013 Asci