Paradyne 3910 Status Message Indicates Dial Backup or, Leased Backup, Call Failure

COMSPHERE 3900 Series Modems

		Table 3-3
		(2 of 4)
		Top-Level Menu Status
Status	Message	Indicates
Dial Backup or	Standby: MR*	The modem is operating in Dial Standby mode.
Leased Backup
	DialBckUp:MR*	The modem is operating in Dial Backup mode at the displayed data
		rate and is configured for Direct mode.
	Backup:MR*	The modem is operating in Dial Backup mode and is configured for
	EC**	error control and data compression on leased lines.
	Standby:MR*	The modem is operating in Dial Standby mode and is configured for
	EC**	error control and data compression on leased lines.
Call Failure	Busy Signal	The answering modem is busy.
	Delayed	As a result of failed call attempts, this number cannot be called at
	Number [	this time. Please try again later.
	Dial Line in Use	The modem is operating on dial networks when another call attempt
		is issued.
	Forbidden	As a result of failed call attempts, this number cannot be called
	Number [	again.
	Invalid Number	The modem has dialed a telephone number not stored in a directory
		location.
	Line	The line is being used by the associated telephone.
	Occupied[[
	No Answer	The answering modem did not answer within the time limit specified
	Tone	by the No Answer Timeout configuration option. The network tones
		(if any) could not be interpreted by the modem.

*MR. Modem Rate indicates the data rate the modem is using. One of the following values appears: 300, 1200, 2400, 4800, 7200, 9600, 12.0 (12,000), 14.4 (14,400), 16.8 (16,800), or 19.2 (19,200) bps.

**EC. Error Control indicates the modem is online and using V.42 or MNP error control. One of the following values appears after the modem rates listed above: MNP2, MNP3, MNP4, MNP5, V42, V42b, or NoEC. (NoEC indicates the modem is connected in Buffer mode rather than error control. If an EC value does not appear, then the modem is in Direct mode.)

***The Alarm Status Messages only appear when the Normal Operation Status Messages appear; the LCD alternates between the two message sets.

**** The Training message may also appear in normal Trellis Multipoint (TMp) operation.

[The Delayed Number and Forbidden Number messages appear only in countries where the number of repeat call attempts are restricted. The regulations vary in each country. If the number is delayed, the value of the delay (in minutes) can be displayed by entering Directory Status (see Call Setup Branch).

[[ The Line Occupied message appears only in countries where the Offhook Detector is enabled. The purpose of the Offhook Detector is to detect whether the telephone associated with the modem is off-hook. It is enabled on a per-country basis, and this setting cannot be changed by a command. The Offhook Detector is enabled in Austria, Germany, and Switzerland.

3-10 November 1996 3910-A2-GN32-30