Paradyne 3910 Change Directory, Dial Standby Command Complete, Call Setup ChangeDirectory

DCP Operation

Dial Standby

Command Complete

F1 F2 F3

If the modem is operating in a Dial Backup mode, the Dial Standby function forces the modem to primary leased lines and the LCD displays the status message Command Complete.

Once the modem is in Dial Standby mode, Return_to_Dial appears on the LCD. Selecting this function forces the modem to the backup network and the LCD displays the status message Command Complete.

Change Directory

Change Directory allows you to enter or modify telephone numbers. The modem has nonvolatile memory locations that allow you to store up to 24 telephone numbers. Each directory location can accept up to 40 characters; this includes the telephone number and dial command modifiers. Any telephone number dialed using the DCP Dial command must appear in a directory location.

NOTE

If the modem is operating on leased lines and has a dial line attached for dial backup purposes, it is required that directory location 1 contain the telephone number used for dial backup.

To access Change Directory from the Call Setup branch, make the following selections:

Call	Setup:	<
Change_Directory
F1	F2	F3

Press the key until Change_Directory appears. Press any function key to select

Change_Directory.

01:551234z
Nxt	"	#

F1 F2 F3

The phone number listed in directory location 1 appears. Select Nxt to display other directory locations.

3910-A2-GN32-30 November 1996 3-59