COMSPHERE 3900 Series Modems

RemClone Status

Bank1:xxxx/yyyy

F1 F2 F3

As data banks are transferred, the local and remote LCD's bottom line displays the status of the download process, and the number of records sent versus the total number of records for that bank.

For Single download applications, if the download is successful, the local modem displays Remote Clone OK and the remote modem displays Frmware Upgrade. If the download took place over the dial network, the modems disconnect when the download is complete.

If the Single download is unsuccessful, RemClone Failed appears on the LCD's top line. Attempt another download from the local modem. If this fails, contact your service representative.

VF Thresholds Update

The VF Thresholds Update function allows you to set the thresholds that determine the Health and Status alarm conditions for the VF parameters. The following thresholds may be edited: RSL High, RSL Low, Sig/Noise, NonLinear, Retrains/15min, Signal Quality, Near Echo, and Far Echo. (For Health and Status alarm conditions, refer to Table 3-6 in the Device Health and Status (DeviceHS) section of this chapter.)

To access VF Thresh Update from the Control branch, make the following selections:

Control:<

VF_Thresh_Update

F1 F2 F3

Press the key until VF_Thresh_Update appears. Press any function key to select

VF_Thresh_Update.

VF Thresholds

Edit

Save

Reset

F1

F2

F3

Select Edit.

In the following example, the RSL High threshold is changed from 09 (±dBm) to 10. This example demonstrates VF threshold editing and saving. With the exception of Signal Quality, all VF thresholds may be modified in this manner. Signal Quality uses a menu selection with possible values of Excelent (Excellent), Good, Fair, Poor, or No Signal. Editing and saving a VF threshold is similar to editing and saving a configuration option. (For another example of editing and saving, refer to the Editing and Saving a Configuration Option section in Chapter 4.)

3-42

November 1996

3910-A2-GN32-30

Page 76
Image 76
Paradyne 3910 VF Thresholds Update, RemClone Status Bank1xxxx/yyyy, Control VFThreshUpdate, VF Thresholds Edit Save Reset