Paradyne 3910 operation manual Dcp Lcd

COMSPHERE 3900 Series Modems

Table 5-4

(10 of 13)

391x Series S-Registers

S-Register		Description	DCP LCD
			Command
			Sequence
S82	V.32bis Autorate (Leased Line). Register determines if Autorating is		Configure\Edit\
	used on leased lines when connected in V.32bis mode.		Leased Line
	Register has the following values:
	0	= Enable
	1	= Disable
	The factory setting is Enable.
S84	AT Command Mode. Register determines how the modem responds to		Configure\Edit\
	valid and invalid AT commands.		DTE Dialer
	Register has the following values:
	0	= Normal
	1	= No ERROR
	2	= No Strap or ERROR
	The factory setting is Normal.
S85	Fast Disconnect. Register allows the modem to disconnect		Configure\Edit\
	immediately after receiving a disconnect command from a local DTE		Line Dialer
	or its own diagnostic control panel.
	Register has the following values:
	0	= Disable
	1	= Enable
	The factory setting is Disable.
S88	Straps When Disconnected. Register determines whether or not		Configure\Edit\
	configuration options in the Active (Saved) configuration area are		Misc
	reloaded to Active (Operating) when a disconnect occurs.
	Register has the following values:
	0 or 231 = No Change
	1 or 232 = Reload
	The factory setting is No Change.

5-24 November 1996 3910-A2-GN32-30