Paradyne 3910 operation manual D0, G0, N5

AT Command Set and S-Registers

Table 5-3

(7 of 8)

391x Series AT Commands

AT			Description			DCP LCD
						Command
Command
						Sequence
\Dn	CTS Control.					Configure\Edit\
	\D0	Forced On. Forces CTS to always ON.				DTE Interface
	\D1	Standard RS232.
	\D2	Wink When Disconnect. CTS is turned OFF for 1 to 2 seconds
		upon a disconnect.
	\D3	Follows DTR. The state of CTS follows the state of DTR.
	\D4	Follows RTS. The state of CTS follows the state of RTS.
\Gn	Modem to Modem Flow Control.					Configure\Edit\
	\G0	Disable.				V42/MNP/Buffer
	\G1	Enable.
\Kn	Buffer Control, Send Break Control, Break Forces Escape.					Break Buffer
						Control:
			Break Buffer	Send Break	Break Forces	Configure\Edit\
						V42/MNP/
			Control:	Control:	Escape:
		\K0	Discard Data	Break First	Enable	Send Break
						Control:
		\K1	Discard Data	Break First	Disable
						Configure\Edit\
		\K2	Keep Data	Break First	Enable
		\K3	Keep Data	Break First	Disable	V42/MNP/Buffer
		\K4	Keep Data	Data First	Enable	Break Forces
		\K5	Keep Data	Data First	Disable
						Escape:
						Configure\Edit\
						DTE Dialer
\Nn	Error Control Mode.					Configure\Edit\
	\N0	Buffer Mode.				V42/MNP/Buffer
	\N1	Direct Mode.
	\N2	MNP or Disconnect.
	\N3	MNP or Buffer.
	\N4	V.42/MNP or Disconnect.
	\N5	V.42/MNP or Buffer.
	\N6	LAPM_or_Disc
	\N7	LAPM_or_Bufr
\Qn	Flow Control of DTE, Flow Control of Modem.					Configure\Edit\
			Flow Control	Flow Control		V42/MNP/Buffer
			of DTE:	of Modem:
		\Q0	Disable	Disable
		\Q1	XON/XOFF	XON/XOFF
		\Q2	CTS to DTE	Disable
		\Q3	CTS to DTE	RTS to Mdm
		\Q4	XON/XOFF	Disable
		\Q5	Disable	XON/XOFF
		\Q6	Disable	RTS to Mdm

3910-A2-GN32-30 November 1996 5-13