Paradyne 3910 Dial Tone, Detect, Busy Tone, Only displays OK, CONNECT, RING, no Carrier

COMSPHERE 3900 Series Modems

Table 5-3

(2 of 8)

391x Series AT Commands

AT		Description			DCP LCD
					Command
Command
					Sequence
Xn	Extended Result Code, Dial Tone Detect, and Busy Tone Detect				Extended
	Configuration Options.				Result Code:
		Extended	Dial Tone	Busy Tone	Configure\Edit\
					DTE Dialer
		Result Code:	Detect:	Detect:
	X0	Disable	Disable	Disable	Dial Tone
					Detect:
	X1	Enable	Disable	Disable
					Configure\Edit\
	X2	Enable	Enable	Disable
					Line Dialer
	X3	Enable	Disable	Enable
	X4	Enable	Enable	Enable	Busy Tone
	X5	Add/EC	Enable	Enable
					Detect:
	X6	Add/V42.MNP	Enable	Enable
	X7	Use DTE Rate	Enable	Enable	Configure\Edit\
					Line Dialer
	Extended Result Code:
	Enable	Displays all result codes listed in Table 5-1 except for
		error control suffix.
	Disable	Only displays OK, CONNECT, RING, NO CARRIER,
		ERROR.
	Add/EC	Displays result codes with /EC suffix.
	Add/V42,MNP	Displays result codes with V.42 or MNP suffix.
	Use DTE Rate	Displays DTE data rate instead of line rate.
	Dial Tone Detect:
	Enable	Sets the modem for dial tone detect.
	Disable	Sets the modem for blind dialing.

NOTE: It may not be possible to disable Dial Tone Detect in some countries.

Busy Tone Detect:

	Enable		Modem monitors for busy tone.
	Disable		Modem ignores busy tone.
Yn	Long Space Disconnect.			Configure/Edit/
	Y0	Disable. Ignores long space.		Line Dialer
	Y1	Enable. Disconnects if long space is detected. Enables
		transmission of a long space.

5-8 November 1996 3910-A2-GN32-30