DCP Operation

To access Abort from the Test branch, make the following selection:

Test:

 

>

Abort

 

Self

F1

F2

F3

Select Abort.

Test:Abort

Command Complete

F1 F2 F3

The modem stops all tests currently in progress and displays the Command Complete status message on the LCD.

To exit this function and remain in the Test branch, press the key. To exit and return to the

Top-Level menu, press the key.

Self

Self performs an internal self-test of the modem, which takes less than a minute to complete. The modem must be offline; otherwise, Invalid Command appears.

WARNING

When this test is run in Remote mode, it will cause the Remote mode session to be lost. The Remote mode session can be reestablished after the self-test is complete (usually one or two minutes). If the remote self-test fails, there will be a Device Failure alarm message when the remote modem's Device Health and Status (DeviceHS) branch is accessed.

To access Self from the Test branch, make the following selection:

Test:

 

>

Abort

 

Self

F1

F2

F3

Select Self. (All LCD cells and DCP status indicators light.)

3910-A2-GN32-30

November 1996

3-47

Page 81
Image 81
Paradyne 3910 operation manual Test Abort Self, TestAbort Command Complete