Paradyne 3910 operation manual Status Message Indicates Firmware, Result Cont, AT Command, Reset

COMSPHERE 3900 Series Modems

		Table 3-3
		(4 of 4)
		Top-Level Menu Status
Status	Message	Indicates
Firmware	Remote Clone	A remote cloning of firmware was successful. This message
Download	OK	appears on the local modem's LCD.
Result
Cont.
	Bcast Clone	A broadcast cloning of firmware has completed. You must look
	Done	under the Control branch for cloning results. This message appears
		on the local modem's LCD.
AT Command	Reset by AT	The modem has performed a reset in response to an ATZ
Reset	command	command.

Messages listed in Table 3-4 are common operational messages that occur during modem operation. These messages normally appear on the second line of the LCD.

	Table 3-4
	Common Operational Messages
Common	Indicates
Operational Message
Please Wait...	A command to a local device takes more than two seconds to complete.
Command Sent...	A command is sent to a remote modem.
No Rem Response or	A remote modem does not respond to a command within 5 seconds.
Remote Modem Fail
Command Complete	A command, issued to a local or remote modem, is completed.
Invalid Command	The modem cannot complete a command.

3-12 November 1996 3910-A2-GN32-30