Paradyne 3910 operation manual Control DownloadCode, DwnLoadSoftware CloneRemote

COMSPHERE 3900 Series Modems

Selecting Clone Remote

NOTE

Clone Remote operations are not supported unless both local and remote modems are 391x Series modems. (The 3800 or 392x Series modems cannot be used in cloning operations with 391x Series modems.)

To access DwnLoadSoftware from the Control branch, make the following selections:

Control:

Download_Code

F1 F2 F3

Press the key until Download_Code appears. Press any function key to select

Download_Code. The DwnLoadSoftware screen appears.

DwnLoadSoftware >

Clone_Remote

F1 F2 F3

Press any function key to select Clone_Remote.

The next screen to appear is determined by the modem's configuration. Refer to the appropriate section (Point-to-Point, Broadcast, or Multipoint).

Clone Remote in Point-to-Point Configurations

Before using Clone Remote in point-to-point configurations, perform the following:

•Make sure the 391x Series modems have an established leased-line connection using either V.33, V.32 terbo, V.32bis, V.32, or V.29 modulation (refer to the Leased Line section in Chapter 4) or a dial network connection using either V.32 terbo, V.32bis or

V.32 modulation (refer to the Dial Line section in Chapter 4).

•Make sure the remote modem's Access From Remote configuration option is enabled (refer to the Misc section in Chapter 4).

•Make sure the password (Remote Access Password configuration option) is the same in both the local and remote modems. (For an example of how to change the password, refer to the Editing and Saving a Configuration Option section in Chapter 4.)

After completing these checks, proceed to the section titled Implementing a Clone Remote

Operation, which follows the descriptions of multipoint cloning operations.

3-36 November 1996 3910-A2-GN32-30