Paradyne 3910 operation manual Flw Cntl of DTE CTStoDTE Nxt CTStoDTE Disable XON/XOFF, Xon/Xoff

COMSPHERE 3900 Series Modems

Table 4-6

(4 of 8)

V.42/MNP/Buffer Configuration Options

Flw Cntl of DTE: CTS_to_DTE

Nxt CTS_to_DTE Disable XON/XOFF

This configuration option is only available if Async/Sync Mode is configured for Async, and Error Control Mode is not configured for DirectMode.

Flow Control of DTE. Determines how the modem controls the flow of data from the DTE.

HCTS to DTE

Method of flow control in which the modem raises and lowers its CTS interface lead to indicate when the DTE should start and stop sending data.

HDisable

The modem cannot control the flow of data from the DTE.

HXON/XOFF

Method of flow control in which the modem sends XON and XOFF characters to the DTE to start and stop the flow of data.

The AT commands for Disable are \Q0, \Q5, and \Q6.

The AT commands for XON/XOFF are \Q1 and\Q4.

The AT commands for CTS to DTE are \Q2 and \Q3.

Flw Cntl of Mdm: RTS_to_Mdm

Nxt RTS_to_Mdm Disable XON/XOFF

This configuration option is only available if Async/Sync Mode is configured for Async, and Error Control Mode is not configured for DirectMode.

Flow Control of Modem. Determines how the DTE controls the flow of data from the modem.

HRTS to Modem

Method of flow control in which the modem respectively starts and stops data transmission based upon the ON and OFF state of the DTE's RTS signal.

HDisable

The DTE cannot control the flow of data from the modem.

HXON/XOFF

Method of flow control in which the modem starts and stops data flow based upon XON and XOFF characters received from the DTE.

The AT commands for Disable are \Q0, \Q2, and \Q4.

The AT commands for XON/XOFF are \Q1 and\Q5.

The AT commands for RTS to Modem are \Q3 and \Q6.

4-42 November 1996 3910-A2-GN32-30