Paradyne 3910 AT Command List, AT Command Format, Result Codes Numbers Word Description

COMSPHERE 3900 Series Modems

Table 5-1

(2 of 2)

Result Codes

Numbers	Numbers	Word	Description
(1)	(2)
26	15	CONNECT 7200/ EC***	Connection at 7200 bps with error control
27	5	CONNECT 1200/ EC*	Connection at 1200 bps with error control
28	28	CONNECT 38400**	Connection at 38,400 bps
29	14	CONNECT 19200/ EC**	Connection at 19,200 bps with error control
30	30	CONNECT 57600**	Connection at 57,600 bps
77	77	FORBIDDEN	Forbidden number
78	78	DELAYED	Delayed number

* Only appears when the Extended Result Codes configuration option is enabled.

** Only appears when the Extended Result Codes configuration option is set for Use_DTE_Rate. This displays the DTE data rate instead of the line rate.

*** Only appears when the Extended Result Codes configuration option is set for Add/EC. If this configuration option is set for Add/V42, MNP, then either V42b, V42, MNP5, MNP4, MNP3, MNP2, or NoEC appears.

AT Command List

AT commands are issued from an asynchronous DTE, such as a PC, and control the modem's operation and software configuration. AT commands are only applicable when the DTE Dialer Type configuration option is set for AT. (Refer to the &Mn and &Qn commands.)

Table 5-2 lists all AT commands supported by the 391x Series modem. The first column lists the AT command. The second column defines and lists all possible values for that command. The Async Dial factory default is listed in bold. The third column lists the key sequence used to enter the equivalent DCP command. Use this to reference commands in Chapter 3 or Chapter 4 if further description is necessary.

AT Command Format

AT commands are entered in Command mode using the following format:

TYPE: ATXn

Where: X is the AT command and n is the specific value for that command.

PRESS: Enter

In Table 5-2, the value for X is listed in the AT Command column and the value for n is listed in the Description column.

5-4 November 1996 3910-A2-GN32-30