Paradyne 3910 operation manual Sub-Network Health and Status Branch, Leased19.2 TestSubHS

DCP Operation

BlksErrd=xxxxxxx displays the number of blocks of data found in error (block size is 1000 bits per block). BlksRcvd=xxxxxxx displays the total number of blocks of data received. The message NoSync appears as a value for BlksErrd while the modem's receiver is synchronizing. The message OvrFlw appears as the value for BlksErrd if the counter overflows.

Press the

key to display BlksRcvd=xxxxxxx, number of blocks of data received.

The Pattern test can be exited and reentered without restarting the test. The BlksErrd and BlksRcvd continue counting.

If the Test Timeout configuration option is enabled, Test Timeout appears at the conclusion of the test. If it is disabled, the test operates until aborted. For more information on the Test Timeout configuration option, refer to the Test section in Chapter 4.

To exit this function and remain in the Test branch, press the key. To exit and return to the

Top-Level menu, press the key.

Sub-Network Health and Status Branch

The Sub-Network Health and Status (SubHS) function is not available on multipoint tributary modems or with certain modulations (V.29, V.33, V.22bis, and V.27bis).

The SubHS branch of the Top-Level menu allows you to display alarm conditions in downstream modems.

ªStatusº

Status

Configure

Plist

Control

Test

Call_Setup

Tlk/Data

Security

Remote

SubHS

To access the SubHS branch from the Top-Level menu, make the following selections:

Leased:19.2

TestSubHS

F1 F2 F3

Press the

key until SubHS appears. Select SubHS.

NOTE

If there are no modems in the multipoint poll list, the message Poll List Empty! appears on the second line of the LCD.

3910-A2-GN32-30 November 1996 3-53