Paradyne 3910 operation manual Dcp Lcd

AT Command Set and S-Registers

Table 5-4

(9 of 13)

391x Series S-Registers

S-Register		Description	DCP LCD
			Command
			Sequence
S72	RTS Antistreaming. Register determines the antistreaming operation		Configure\Edit\
	of the modem.		DTE Interface
	Register has the following values:
	0	= Disable
	1	= 10 sec
	2	= 30 sec
	3	= 1 min
	4	= 2 min
	5	= 3 min
	6	= 5 min
	The factory setting is Disable.
S74	Network Position Identification. Register identifies each modem as		Configure\Edit\
	either a control or tributary modem.		Misc
	Register has the following values:
	0	= Tributary
	1	= Control
	The factory setting is Tributary.
S75	Network Management Address. Register determines the modem's		Configure\Edit\
	network address. This address is used when accessing the modem		Dial
	from the 6700 Series NMS.
	Enter a value from 0 (network address 001) to 255 (network address
	256). The factory setting is 0.
S76	V.32bis Autorate (Dial Line). Register determines if Autorating is used		Configure\Edit\
	on dial lines when connected in V.32bis mode.		Dial Line
	Register has the following values:
	0	= Enable
	1	= Disable
	The factory setting is Enable.
S78	V.32bis Automode (Dial Line). Register allows the modem (when		Configure\Edit\
	operating on dial lines) to automatically detect and connect to the		Dial Line
	remote modem's modulation scheme.
	Register has the following values:
	0	= Enable
	1	= Disable
	The factory setting is Enable.

3910-A2-GN32-30 November 1996 5-23