Paradyne 3910 operation manual Dcp Lcd

COMSPHERE 3900 Series Modems

Table 5-2

(2 of 3)

391x Series AT Commands

AT		Description	DCP LCD
			Command
Command
			Sequence
Dn (cont.)	@	Ð Quiet answer. Wait for five seconds of silence after dialing
		the number. If the silence is not detected, the modem
		sends either a NO ANSWER result to the DTE.
	!	Ð Hook flash. This causes the modem to go on-hook for 0.5
		seconds then return to off-hook.
	;	Ð Return to Command mode. Modem returns to Command
		mode after dialing a number without disconnecting the call.
	Space Ð Ignored by the dial string, can be included to enhance
		readability.
		Ð Ignored by the dial string, can be included to enhance
	±
		readability.
	( )	Ð Ignored by the dial string, can be included to enhance
		readability.
DS=n	Dial Stored Number. Dials the number stored in Location n (1±24). (To		Call Setup\Dial\
	store a telephone number, refer to the &Zn=x command.)		Dial Directory:
En	Command Character Echo.		Configure\Edit\
	E0 Disables echo to the DTE.		DTE Dialer
	E1 Enables echo to the DTE.
Hn	Hook Switch Control.		H0: Call Setup\
	H0 Modem goes on-hook.		Disconnect or
			Control\Remove
	H1 Modem goes off-hook.
			Make Busy
			H1: Control\
			Make Busy
In	Identification.		Status\Identity
	I0 Displays product code Ð 144.
	I1 Displays 3-digit firmware revision number.
	I2 Performs an EPROM check.
Ln	Speaker Volume.		Control\Speaker
	L0	Selects low volume.	Configure\Edit\
			Misc
	L1	Selects low volume.
	L2	Selects medium volume.
	L3	Selects high volume.
Mn	Speaker On/Off.		Control\Speaker
	M0	Speaker always OFF.	Configure\Edit\
			Misc
	M1 Speaker ON until carrier signal is detected.
	M2	Speaker always ON.

5-6 November 1996 3910-A2-GN32-30