Paradyne 3910 operation manual Installing a Model 3911 Modem

Models: 3910

1 244
Download 244 pages 43.44 Kb
Page 32
Image 32

COMSPHERE 3900 Series Modems

Figure 2-2. Installing a Model 3911 Modem

2.At the front of the carrier, hold the modem vertically, with the latch on its faceplate in the open position, and insert it into the top and bottom card guides of one of the slots numbered 1±16 (Figure 2-2).

Slide the modem into the slot, aligning the modem with the rear connector plate, until the backplane connector and DTE connector seat firmly into the back of the carrier. The faceplate latch automatically closes as you push the modem into the carrier. To lock the modem into the carrier, press the faceplate latch until a ªclickº is heard.

3.If the carrier is ON, the Power LED on the faceplate of the 3911 lights. After several seconds the modem completes its power-up self-test, in which all faceplate LEDs light.

Return to the rear of the carrier and tighten the rear connector plate.

If the modem is to communicate with an installed SDCP, install the modem as described above and perform the following steps:

1. Press the

Select

key on the SDCP. The cursor appears in the carrier selection entry.

2.Press the F1 ( ￿ ) or F2 ( ￿ ) key until the carrier number you want appears on the LCD.

The carrier number selection has a range of 1 to 8 since a single SDCP can control a configuration of up to eight carriers. (This is only possible if the SDU is installed.)

3. Press the

key to position the cursor on the slot selection entry.

4.Press the F1 ( ￿ ) or F2 ( ￿ ) key until the slot number you want (1±16) appears on the LCD.

2-10

November 1996

3910-A2-GN32-30

Page 32
Image 32
Paradyne 3910 operation manual Installing a Model 3911 Modem