Pioneer DEH-P55BT Audio Adjustments, Using the equalizer, Recalling equalizer curves

Audio Adjustments

#FAD : 0 is the proper setting when only two speakers are used.

#When the rear output setting is R-SP :S/W, you cannot adjust front/rear speaker balance. Refer to Setting the rear output and subwoofer controller on page 65.

3Push MULTI-CONTROL left or right to adjust left/right speaker balance.

Each time MULTI-CONTROL is pushed left or right, the left/right speaker balance moves to- wards the left or right.

L 15 to R 15 is displayed as the left/right speaker balance moves from left to right.

Using the equalizer

The equalizer lets you adjust the equalization to match car interior acoustic characteristics as desired.

Recalling equalizer curves

There are six stored equalizer curves which you can easily recall at any time. Here is a list of the equalizer curves:

Display	Equalizer curve
SUPER BASS	Super bass
POWERFUL	Powerful
NATURAL	Natural
VOCAL	Vocal
CUSTOM	Custom
FLAT	Flat

!CUSTOM is an adjusted equalizer curve that you create.

!When FLAT is selected no supplement or correction is made to the sound. This is useful to check the effect of the equalizer

Section

12

curves by switching alternatively between	English
FLAT and a set equalizer curve.

1Press AUDIO to select POWERFUL. Press AUDIO until POWERFUL appears in the

display.

# If the equalizer curve has been previously se- lected, the curve of that previously selected will be displayed instead of POWERFUL.

2Push MULTI-CONTROL left or right to select the equalizer.

Each time MULTI-CONTROL is pushed left or right, equalizer curves are selected in the fol- lowing order:

SUPER BASS—POWERFUL—NATURAL— VOCAL—CUSTOM—FLAT

Adjusting equalizer curves

You can adjust the currently selected equalizer curve setting as desired. Adjusted equalizer curve settings are memorized in CUSTOM.

1 Press AUDIO to select EQ.

Press AUDIO until EQ appears in the display.

2Push MULTI-CONTROL left or right to select the equalizer band to adjust.

Each time MULTI-CONTROL is pushed left or right, equalizer bands are selected in the fol- lowing order:

EQ-L (low)—EQ-M (mid)—EQ-H (high)

3Push MULTI-CONTROL up or down to adjust the level of the equalizer band. Each time MULTI-CONTROL is pushed up or down, the level of the equalization band in- creases or decreases.

+6 to –6 is displayed as the level is increased

or decreased.

# You can then select another band and adjust the level.

En 59