Pioneer DEH-P55BT operation manual Initial Settings, Turning the off clock display on or off

Section

13 Initial Settings

3Push MULTI-CONTROL up or down to set the clock.

Pushing MULTI-CONTROL up will increase the selected hour or minute. Pushing

MULTI-CONTROL down will decrease the se- lected hour or minute.

Turning the off clock display on or off

If the off clock display is turned on, when the sources are off, the calendar and the clock dis- play appears on the display.

1Press FUNCTION to select CLOCK. Press FUNCTION repeatedly until CLOCK ap- pears in the display.

2Push MULTI-CONTROL up to turn the off clock display on.

CLOCK :ON appears in the display.

# To turn the off clock display off, push MULTI-CONTROL down.

Setting the FM tuning step

Normally the FM tuning step employed by seek tuning is 50 kHz. When AF or TA is on, the tuning step automatically changes to 100 kHz. It may be preferable to set the tuning step to 50 kHz when AF is on.

1 Press FUNCTION to select FM.

Press FUNCTION repeatedly until FM appears in the display.

2Push MULTI-CONTROL left or right to select the FM tuning step.

Pushing MULTI-CONTROL left or right will switch the FM tuning step between 50 kHz and 100 kHz while AF or TA is on. The selected FM tuning step will appear in the display.

Note

The tuning step remains at 50 kHz during manual tuning.

Switching Auto PI Seek

The unit can automatically search for a differ- ent station with the same programming, even during preset recall.

1Press FUNCTION to select A-PI. Press FUNCTION repeatedly until A-PI ap- pears in the display.

2Push MULTI-CONTROL up to turn Auto PI seek on.

A-PI :ON appears in the display.

# To turn Auto PI seek off, push MULTI-CONTROL down.

Switching the warning tone

If the front panel is not detached from the head unit within four seconds of turning off the ignition, a warning tone will sound. You can turn off the warning tone.

1Press FUNCTION to select WARN. Press FUNCTION repeatedly until WARN ap- pears in the display.

2Push MULTI-CONTROL up to turn warn- ing tone on.

WARN :ON appears in the display.

# To turn warning tone off, push MULTI-CONTROL down.

Switching the auxiliary setting

Auxiliary equipments connected to this unit can be activated individually. Set each AUX source to ON when using. About connecting or using auxiliary equipments, refer to Using the AUX source on page 66.

64 En