Pioneer DEH-P55BT operation manual Setting the rear output and subwoofer controller

Initial Settings

1Press FUNCTION to select AUX1/AUX2. Press FUNCTION repeatedly until AUX1/ AUX2 appears in the display.

2Push MULTI-CONTROL up to turn AUX1/AUX2 on.

AUX1 :ON/AUX2 :ON appears in the display.

# To turn AUX off, push MULTI-CONTROL down.

Setting the rear output and subwoofer controller

This unit’s rear output (rear speaker leads out- put and RCA rear output) can be used for full- range speaker (R-SP :FUL) or subwoofer (R-SP :S/W) connection. If you switch the rear output setting to R-SP :S/W, you can connect a rear speaker lead directly to a subwoofer without using an auxiliary amp.

Initially, the unit is set for rear full-range speak- er connection (R-SP :FUL). When rear output is connected to full range speakers (when R-SP :FUL is selected), you can connect other full range speakers (P/O :FUL) or a subwoofer (P/O :S/W) to the RCA rear output.

1Press FUNCTION to select R-SP. Press FUNCTION repeatedly until R-SP ap- pears in the display.

2Push MULTI-CONTROL up or down to switch the rear output setting.

Pushing MULTI-CONTROL up or down will switch between R-SP :FUL (full-range speaker) and R-SP :S/W (subwoofer) and that status

will be displayed.

# When no subwoofer is connected to the rear

output, select R-SP :FUL.

# When a subwoofer is connected to the rear

output, set for subwoofer R-SP :S/W.

# When the rear output setting is R-SP :S/W, you cannot operate the following procedure.

Section

13

3 Push MULTI-CONTROL left or right to	English
switch the subwoofer output or rear out-
put.
Pushing MULTI-CONTROL left or right will
switch between P/O :S/W and P/O :FUL and
that status will be displayed.

Notes

!Even if you change this setting, there is no output unless you turn the subwoofer output on (refer to Using subwoofer output on page 60).

!If you change this setting, subwoofer output

in the audio menu return to the factory settings.

Switching the telephone muting/attenuation

Sound from this system is muted or attenu- ated automatically when the signal from the equipment with mute function is received.

!The sound is muted or attenuated, MUTE or ATT are displayed and no audio adjust- ment is possible.

!Sound from this system returns to normal when the muting or attenuation is can- celed.

1 Press FUNCTION to select TEL.

Press FUNCTION repeatedly until TEL appears in the display.

2Push MULTI-CONTROL left or right to switch the telephone muting/attenuation. Pushing MULTI-CONTROL left or right will switch between TEL ATT (attenuation) and

TEL MUTE (muting) and that status will be dis- played.

En 65