Section

12 Audio Adjustments

Boosting the bass

Bass boost function boosts the bass level of sound lower than 100 Hz. The more the bass level is increased, the more the bass sound is emphasized and the entire sound becomes powerful. When using this function with the subwoofer, the sound under the cut-off fre- quency is boosted.

1 Press AUDIO to select BASS.

Press AUDIO until BASS appears in the dis- play.

2Push MULTI-CONTROL up or down to select a desired level.

0to +6 is displayed as the level is increased or decreased.

Front image enhancer (F.I.E.)

The F.I.E. (Front Image Enhancer) function is a simple method of enhancing front imaging by cutting mid- and high-range frequency output from the rear speakers, limiting their output to low-range frequencies. You can select the fre- quency you want to cut.

Precaution

When the F.I.E. function is deactivated, the rear speakers output sound of all frequencies, not just bass sounds. Reduce the volume before disenga- ging F.I.E. to prevent a sudden increase in vo- lume.

1 Press AUDIO to select FIE.

Press AUDIO until FIE appears in the display.

#When the rear output setting is R-SP :S/W, you cannot select FIE.

#When the HPF function is on, you cannot se- lect FIE.

2Push MULTI-CONTROL up to turn F.I.E.

on.

# To turn F.I.E. off, push MULTI-CONTROL down.

3Push MULTI-CONTROL left or right to select a desired frequency.

Each time MULTI-CONTROL is pushed left or right, frequencies are selected in the following order:

100—160—250 (Hz)

Notes

!After turning the F.I.E. function on, use the bal- ance adjustment (refer to page 58) and adjust front and rear speaker volume levels until they are balanced.

!Turn the F.I.E. function off when using a 2- speaker system.

Adjusting source levels

SLA (source level adjustment) lets you adjust the volume level of each source to prevent ra- dical changes in volume when switching be- tween sources.

!Settings are based on the FM tuner volume level, which remains unchanged.

1Compare the FM tuner volume level with the level of the source you wish to ad- just.

2Press AUDIO to select SLA.

Press AUDIO until SLA appears in the display.

3Push MULTI-CONTROL up or down to adjust the source volume.

Each time MULTI-CONTROL is pushed up or down, source volume increases or decreases. SLA : +4 to SLA : –4 is displayed as the source volume is increased or decreased.

Notes

!The MW/LW tuner volume level can also be adjusted with source level adjustments.

!The built-in CD player and the multi-CD player are set to the same source level adjustment volume automatically.

!External unit 1 and external unit 2 are set to

the same source level adjustment volume automatically.

62 En

Page 62
Image 62
Pioneer DEH-P55BT operation manual Audio Adjustments Boosting the bass, Front image enhancer F.I.E, Adjusting source levels