Pitney Bowes DM550, DM500 manual Tape still on Roll, Tape has run out

9 • Maintaining and Updating

Tape still on Roll	2. Drop the new tape in so that it
continued	feeds from the bottom of the roll
	to the right.
	The protective backing on the
	tape should be facing down.
	Pull about 12 inches of tape
	from the end of the roll up to-
	ward the cover and then loop it
	down into the slot.

CAUTION: Do not load a tape strip that has any pink or black stripes showing. This will cause the last piece of tape to jam in the machine which and you will need to place a service call.

3.From the “Out of Tape” or "Load Tape" screen, select Load Tape. Feed the tape into the slot while the tape motor is running. The machine au- tomatically cuts off the excess tape.

4.Close the feed cover.

Tape has run out

1.If the system actually runs out of tape, the “Out of Tape” screen ap- pears.

2.Open the cover and select Unload Tape from the “Out of Tape” screen.

3.Remove any remaining tape on the tape roll. Follow steps 2 - 4 in the Tape still on roll procedure above.

9-4 SV60890 Rev. G