Samsung CLP-600 manual Restoring the Wireless Configuration, Hexadecimal Alphanumeric

•Security Mode: “None”, “Static WEP”, or “Enhanced” The Samsung print server provides three kinds of Security Modes (such as “None” Static WEP, and Enhanced) for easy setting of wireless network security. “None” security mode is used when the validation of wireless device's identity and data encryption are not required for your network. Static WEP uses WEP (Wired Equivalent Privacy) algorithm suggested by IEEE802.11 standard for security. A WEP algorithm provides data encryption and decryption for data communication. Static WEP security requires WEP key for data encryption, decryption, and authentication. Enhanced provides more security and better key management than Static WEP by using IEEE802.1X EAP authentication and dynamic encryption (such as dynamic WEP, TKIP, AES). Enhanced cannot be configured on printer's control panel. In order to choose Enhanced as security mode, you must use SWS (Syncthru Web Service). For more information about Enhanced settings, see the Network Printer User’s Guide. The default setting is “None”.

•Authentication: “Open System” or “Shared Key”. This option is available in Static WEP mode only. If required by your network, the proper authentication method must be configured on the print server. The default setting is “Open System”.

•Encryption: “64-bit WEP” or “128-bit WEP”. This option is available in Static WEP mode only. If your network uses Static Encryption keys, you must configure the Encryption keys. You can configure up to four keys. The active key must match the value and active key position (for example, Key 1) configured on other wireless devices. The default setting is “64-bit WEP”.

•Using Key: Select the key to use in your network. This option is available in Static WEP mode only. The default setting is “Key 1”.

•Key Type: Select the key type of your network. This option is available in Static WEP mode only. The default setting is “Hexadecimal”.

•Key1, Key2, Key3, Key4: Enter the key number for

“Encryption”. This option is available in Static WEP mode only. The default setting is 0 for all keys. The numbers you can enter are as follows:

	Hexadecimal	Alphanumeric
64-bit WEP	10 digits	5 characters
128-bit WEP	26digits	13 characters

NOTE: Your changes for wireless parameters will be applied after resetting the print server. In order to reset the print server, see “Rebooting the Network Interface Card” on page 8.4.

Restoring the Wireless Configuration

You can return the wireless configuration only to its default settings.

1In ready mode, press the Menu button ( ) until you see “Network” on the bottom line of the display. Press the Enter button ( ) to access the menu.

2Press the Enter button ( ) when “Config Network” displays on the bottom line.

3Press the scroll button ( or ) until “Yes” displays on the bottom line. Press the Enter button ( ).

4Press the Upper Level button ( ).

5Press the scroll button ( or ) until “Config WLAN” displays on the bottom line. Press the Enter button ( ).

6Press the scroll button ( or ) until “Yes” displays on the bottom line. Press the Enter button ( ).

7Press the Upper Level button ( ).

8Press the scroll button ( or ) until “WLAN Default” displays on the bottom line.

9Press the Enter button ( ) to confirm the selection.

NOTE: This feature will be applied after resetting the print server. In order to reset the print server, see “Rebooting the Network Interface Card” on page 8.4.

8.5

Using Your Printer on a Network (CLP-600N only)