I/O PORTS

S3F80JB

 

 

 

Table 9-1. S3F80JB Port Configuration Overview (44-QFP)

 

 

Port

Configuration Options

Port 0

8-bit general-purpose I/O port; Input or push-pull output; external interrupt input on falling edges,

 

rising edges, or both edges; all P0 pin circuits have noise filters and interrupt enable/disable

 

register (P0INT) and pending control register (P0PND); Pull-up resistors can be assigned to

 

individual P0 pins using P0PUR register settings. This port is dedicated for key input in IR

 

controller application.

Port 1

8-bit general-purpose I/O port; Input without or with pull-up, open-drain output, or push-pull output.

 

This port is dedicated for key output in IR controller application.

Port 2

8-bit general-purpose I/O port; Input or push-pull output. The P2 pins, P2.0–P2.7, can be used as

 

external interrupt inputs and have noise filters. The P2INT register is used to enable/disable

 

interrupts and P2PND bits can be polled by software for interrupt pending control. Pull-up resistors

 

can be assigned to individual P2 pins using P2PUR register settings. Also P2.4-P2.7 can be

 

assigned individually as analog input pin for comparator.

P3.0–P3.1

P3.0 is configured input functions (Input mode, with or without pull-up, for normal input or T0CAP)

 

or output functions (push-pull or open-drain output mode, for normal output or T0PWM). P3.1 is

 

configured input functions (Input mode, with or without pull-up, for normal input) or output

 

functions (push-pull or open-drain output mode, for normal output or REM function). P3.1 is

 

dedicated for IR drive pin and P3.0 can be used for indicator LED drive.

P3.2–P3.3

P3.2 is configured only input pin with pull-up resistor (for normal input or T0CK function). P3.3 is

 

configured only input pin with pull-up resistor (for normal input, T1CAP function, or T2CAP

 

function). P3.3 can be used for IR signal capture pin with T1CAP function or T2CAP function.

P3.4–P3.5

2-bit general-purpose I/O port; Input without or with pull-up, open-drain output, or push-pull output.

P3.7

P3.7 is not configured for I/O pin and it only used to control carrier signal on/off.

Port 4

8-bit general-purpose I/O port; Input without or with pull-up, open-drain output, or push-pull output.

 

This port is dedicated for key output in IR controller application.

9-2

Page 240
Image 240
Samsung manual S3F80JB Port Configuration Overview 44-QFP, Port Configuration Options, P3.0-P3.1