C
ONFIGURING
THE
S
WITCH
2-86
•IGMP Report Delay – Sets the time (in seconds) between receiving
an IGMP Report for an IP multicast address on a port before the
switch sends an IGMP Query out of that port and removes the entry
from its list. (Default: 10 seconds, Range: 5 - 30.)
•Query Timeout – Sets the time (in seconds) the switch waits after the
previous querier has stopped querying before it takes over as the
querier. (Default:300 seconds, Range: 300 - 500.)
•IGMP Version – Sets the protocol version for compatibility with
other devices on the network. (Default: 2, Range: 1 - 2.)
Note: All systems on the subnet must support the same version. Some
attributes are only enabled for IGMPv2, including IGMP Report
Delay and IGMP Query Timeout.
Web Inte rfac e
Click IGMP/IGMP Configuration. Adjust the IGMP settings as required,
and then click “Apply.” (The default settings are shown below.)