VLAN C
OMMANDS
3-99switchport mode
Use this command to configure the VLAN membership mode for a port.
Use the no form to restore the default.
Syntax
switchport mode {trunk | hybrid}
no switchport mode
•trunk - Specifies a port as an end-point for a VLAN trunk. A
trunk is a direct link between two switches, so the port transmits
and receives tagged frames that identify the source VLAN.
•hybrid - Keyword that specifies a hybrid VLAN interface. The
port may receive or transmit tagged or untagged frames. Any
frames that are not tagged will be assigned to the default VLAN.
Default Setting
All ports are in hybrid mode with the PVID set to VLAN 1.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
Configures VLAN membership mode for a port.
Example
The following shows how to set the configuration mode to port 1,
and then set the switchport mode to hybrid:
Related Commands
switchport acceptable-frame-types
Console(config)#interface ethernet 1/1
Console(config-if)#switchport mode hybrid
Console(config-if)#