SMC Networks SMC7724M/VSW manual Snmp-server host, Snmp-server contact

SNMP COMMANDS

Example

Console(config)#snmp-server location R&D 3F

Console(config)#

Related Commands

snmp-server contact

snmp-server host

Use this command to specify the recipient of a Simple Network Management Protocol notification operation. Use the no form to remove the specified host.

Syntax

snmp-server host host-addr community-string no snmp-server host host-addr

•host-addr- Name or Internet address of the host (the targeted recipient)

(Maximum host addresses: 5 trap destination ip address entries)

•community-string- Password-like community string sent with the notification operation. Though you can set this string using the snmp-server host command by itself, we recommend you define this string using the snmp-server community command prior to using the snmp-server host command. (maximum length: 32 characters)

Default Setting

None

Command Mode

Global Configuration

Command Usage

If you do not enter an snmp-server host command, no notifications are sent. In order to configure the switch to send SNMP notifications, you must enter at least one snmp-server host command. To enable multiple hosts, you must issue a separate snmp-server host command for each host.

3-47