UPGRADING FIRMWARE VIA THE SERIAL PORT

File NameS/Up Type Size Date

--------------------------------- ---- ---- ---------- ----------

$logfile_1

0

3

64

9

$logfile_2

0

3

64

13

Factory_Default_Config.cfg

0

5

2574

24

config1

0

5

3286

6974

d0052.bix

1

1

84992

39

ip

0

5

2686

1577

v1811.bix

0

2

1198856

627

startup

1

5

3286

243

v1812.bix

1

2

1197056

1018

--------------------------------- ---- ---- ---------- ----------

[X]modem Download [D]elete File [S]et Startup File [C]hange Baudrate [Q]uit

Select>

5.Press <c> to change the baud rate of the switch’s serial connection.

6.There are two baud rate settings available, 9600 and 115200. Using the higher baud rate minimizes the time required to download firmware code files. Press <b> to select the option for 115200 baud.

7.Set your PC’s terminal emulation software to match the 115200 baud rate. Press <Enter> to reset communications with the switch.

Select>

Change baudrate [A]9600 [B]115200

Baudrate set to 115200

8.You can store a maximum of only two runtime and two diagnostic code files in the switch’s Flash memory. Use the [D]elete File command to remove a runtime or diagnostic file that is not set as the startup file (i.e, the S/Up setting for the file must be set to “0” before it can be deleted).

9.Press <x> to start to download the new code file. If using Windows HyperTerminal, click the “Transfer” button, and then click “Send File....” Select the XModem Protocol and then use the “Browse” button to select the required firmware code file from your PC system. The “Xmodem file send” window displays the progress of the download procedure.

Note: The download file must be an SMC7724M/VSW binary software file from SMC.

A-3

Page 303
Image 303
SMC Networks SMC7724M/VSW manual Upgrading Firmware VIA the Serial Port