SMC Networks SMC7724M/VSW IP Commands, LC Line Configuration, VC Vlan Database Configuration

IP COMMANDS

IP Commands

An IP address may be used for management access to the switch over your network. By default, the switch’s IP address is set via DHCP. If you wish to manually configure an IP address, you need to change the switch’s default settings (IP address 0.0.0.0 and netmask 255.0.0.0) so that they are compatible with your network. You may also need to a establish a default gateway between the switch and management stations that exist on another network segment.

Command	Function	Mode	Page
ip address	Sets the IP address for this device	IC	3-52
ip dhcp restart	Submits a BOOTP or DCHP client request	PE	3-53
ip default-gateway	Defines the default gateway through which an	GC	3-54
	in-band management station can reach this
	device
show ip interface	Displays the IP settings for this device	PE	3-55
show ip redirects	Displays the default gateway configured for	PE	3-55
	this device
ping	Sends ICMP echo request packets to another	NE,	3-56
	node on the network	PE

Note: The access mode shown in the table is indicated by these abbreviations: NE (Normal Exec), PE (Privileged Exec), GC (Global Configuration), IC (Interface Configuration),

LC (Line Configuration), VC (VLAN Database Configuration.)

3-51