C
OMMAND
L
INE
I
NTERFACE
3-120
seconds - The frequency at which the switch sends IGMP host-query
messages. (Range: 60-125)
Default Setting
125 seconds
Command Mode
Global Configuration
Example
The following shows how to configure the query interval to 100 seconds:
ip igmp snooping query-max-response-time
Use this command to configure the snooping report delay. Use the no
form of this command to restore the default.
Syntax
ip igmp snooping query-max-response-time seconds
no ip igmp snooping query-max-response-time
seconds - The report delay advertised in IGMP queries. (Range: 5-30)
Default Setting
10 seconds
Command Mode
Global Configuration
Command Usage
• The switch must be using IGMPv2 for this command to take effect.
• The command sets the time the switch waits after receiving an IGMP
report (for an IP multicast address) on a port before it sends an IGMP
Query out that port and then removes the entry from its list.
Console(config)#ip igmp snooping query-interval 100
Console(config)#