SMC Networks SMC7724M/VSW manual Telnet Connection

COMMAND LINE INTERFACE

2.Enter the necessary commands to complete your desired tasks.

3.Exit the session with the “quit” or “exit” command.

After connecting to the system through the console port, the login screen displays:

User Access Verification

Username: admin

Password:

CLI session with the host is opened.

To end the CLI session, enter [Exit].

Console#

Telnet Connection

Telnet operates over the IP transport protocol. In this environment, your management station and any network device you want to manage over the network must have a valid IP address. Valid IP addresses consist of four numbers, 0 to 255, separated by periods. Each address consists of a network portion and host portion. For example, the IP address assigned to this switch, 10.1.0.1, consists of a network portion (10.1.0) and a host portion (1.)

To access the switch through a Telnet session, you must first set the IP address for the switch, and set the default gateway if you are managing the switch from a different IP subnet. For example:

Console(config)#interface vlan 1

Console(config-if)#ip address 10.1.0.1 255.255.255.0

Console(config-if)#exit

Console(config)#ip default-gateway 10.1.0.254

If your corporate network is connected to another network outside your office or to the Internet, you need to apply for a registered IP address. However, if you are attached to an isolated network you may use any IP address that matches the network segment to which you are attached.

3-2