SMC Networks SMC7724M/VSW manual 100

CONFIGURING THE SWITCH

•Mode – Indicates VLAN membership mode for a port. (Configure via CLI, see page 3-99.)

•Trunk – Specifies a port as an end-point for a VLAN trunk. A trunk is a direct link between two switches, so the port transmits and receives tagged frames that identify the source VLAN.

•Hybrid – Specifies a hybrid VLAN interface. The port may receive or transmit tagged or untagged frames. Any frames that are not tagged will be assigned to the default VLAN.

Web Interface

Click VLAN/VLAN Trunk Configuration or VLAN Port Configuration. Fill in the required settings for each interface, click “Apply.”

Command Line Interface

This example sets port 1 to accept only tagged frames, assigns PVID 3 as the native VLAN ID, enables GVRP, sets the GARP timers, and then sets the switchport mode to hybrid.

Console(config)#interface ethernet		1/1	3-69
Console(config-if)#switchport	acceptable-frame-types tagged		3-100
Console(config-if)#switchport	ingress-filtering		3-100
Console(config-if)#switchport	native vlan 3		3-101
Console(config-if)#switchport	gvrp		3-108
Console(config-if)#garp timer	join	10	3-110
Console(config-if)#garp timer	leave 90		3-110
Console(config-if)#garp timer	leaveall 2000		3-110
Console(config-if)#switchport	mode	hybrid	3-99
Console(config-if)#

2-58