SMC Networks SMC7724M/VSW manual Mapping IP Port Priority, Command Line Interface

MAPPING LAYER 3/4 PRIORITIES TO COS VALUES

Command Line Interface

The following example globally enables DSCP Priority service on the switch, maps DSCP value 1 to CoS value 0 on port 5, and then displays all the DSCP Priority settings for that port.

Console(config)#map			ip dscp	3-133
Console(config)#interface ethernet 1/5				3-69
Console(config-if)#map ip dscp 1 cos 0				3-134
Console(config-if)#end
Console#show map ip			dscp ethernet 1/5	3-137
DSCP mapping status: disabled
Port	DSCP COS
--------- ---- ---
Eth 1/ 5	0	0
Eth 1/ 5	1	0
Eth 1/ 5	2	0
Eth 1/ 5	3	0
.
.
.
Eth 1/ 5	61	0
Eth 1/ 5	62	0
Eth 1/ 5	63	0
Console#

Mapping IP Port Priority

In the IP Port Priority page, for each switch port or trunk, you can map IP ports (TCP/UDP ports) to the switch’s 4 traffic class queues.

Fields and Attributes

•Current IP Port Table – displays a list of IP ports with their mapped class of service queues.

•IP Port – sets a new IP port number.

•Class of Service – sets a new class of service for an IP port. Note that “0” represents low priority and “3” represents high priority.

2-75