SMC Networks SMC7724M/VSW manual Switchport priority default, 125

PRIORITY COMMANDS

Command	Function	Mode	Page
show map ip port	Shows the IP port map	PE	3-135
show map ip	Shows the IP precedence map	PE	3-136
precedence
show map ip dscp	Shows the IP DSCP map	PE	3-137

Note: The access mode shown in the table is indicated by these abbreviations: NE (Normal Exec), PE (Privileged Exec), GC (Global Configuration), IC (Interface Configuration),

LC (Line Configuration), VC (VLAN Database Configuration.)

switchport priority default

Use this command to set a priority for incoming untagged frames, or the priority of frames received by the device connected to the specified interface. Use the no form to restore the default value.

Syntax

switchport priority default default-priority-idno switchport priority default

default-priority-id- The priority number for untagged ingress traffic. The priority is a number from 0 to 7. Seven is the highest priority.

Default Setting

The priority is not set, and the default value for untagged frames received on the interface is zero. The switch is not instructed what to do with the priority.

Command Mode

Interface Configuration (Ethernet, Port Channel)

Command Usage

•The precedence for priority mapping is IP Port, IP Precedence or IP DSCP, and default switchport priority.

•The default port priority applies if the incoming frame is an untagged frame received from a VLAN trunk or a static-access port. This priority does not apply to IEEE 802.1Q VLAN tagged frames. If the

3-125