SMC Networks SMC7724M/VSW manual Ip address, IP address Netmask, Interface Configuration Vlan

COMMAND LINE INTERFACE

ip address

Use this command to set the IP address for this device. Use the no form to restore the default IP address.

Syntax

ip address {ip-address netmask bootpdhcp} no ip address

•ip-address- IP address

•netmask - Network mask for the associated IP subnet. This mask identifies the host address bits used for routing to specific subnets.

•bootp - Obtains IP address from BOOTP.

•dhcp - Obtains IP address from DHCP.

Default Setting

IP address: 0.0.0.0

Netmask: 255.0.0.0

Command Mode

Interface Configuration (VLAN)

Command Usage

•You must assign an IP address to this device to gain management access over the network. You can manually configure a specific IP address, or direct the device to obtain an address from a BOOTP or DHCP server. Valid IP addresses consist of four numbers, 0 to 255, separated by periods. Anything outside this format will not be accepted by the configuration program.

•If you select the bootp or dhcp option, IP is enabled but will not function until a BOOTP or DHCP reply has been received. Requests will be broadcast periodically by this device in an effort to learn its IP address. (BOOTP and DHCP values can include the IP address, default gateway, and subnet mask.)

3-52